Skip to content

5. Practice in Packet Tracer

Cisco Packet Tracer lets you build and run a network entirely virtually — drag on real device models, cable them exactly like physical gear, and actually test whether traffic flows.

Build your Lesson 4 plan

  1. Drag on your devices: 2 end devices (PCs), 1 switch, 1 router.
  2. Cable them to match your star topology: each PC to the switch, the switch to the router.
  3. Click each PC, open its IP Configuration, and enter the IP address and subnet mask from your plan.
  4. Click the router and configure its interface with an address on the same network.

Prove it works

Click a PC, open its command line, and ping the other PC:

C:\> ping 192.168.1.20

A successful ping means the whole chain — cabling, switch, IP configuration — is actually correct. A failed ping means something in your plan or your build doesn't match; that's the real skill here, not just clicking through steps.

Try it

Build your Lesson 4 topology and get a successful ping between both PCs. If it fails, work backward: check cabling first, then each device's IP configuration, before assuming anything else is wrong.

Tip

Packet Tracer color-codes each link green (working) or red (a problem, often a cabling/port mismatch) — use that before you even try to ping anything.

Next: Wireless Networking →