Skip to content

4. Wireless and Network Security

Networking Fundamentals already covered WPA2/WPA3 (Lesson 6) and firewalls (Lesson 8) — this lesson is about the security decisions layered on top of that hardware and those protocols.

Network segmentation

Splitting a network into separate zones, so a problem in one doesn't automatically reach everything else. A VLAN does this on a single physical network — guest Wi-Fi traffic, for instance, kept completely separate from the devices actually running an organization's real work, even though they might share the same switches and access points.

VPNs

A VPN wraps traffic in an encrypted tunnel to another network — Mobile Devices, Lesson 7 covered this from the device side (a VPN profile pushed by MDM). The same concept applies to entire sites: connecting two office networks together securely over the public internet, as if they were one network.

Firewall rules, revisited

A firewall (Networking Fundamentals, Lesson 8) doesn't just block or allow everything — real rules are specific: which ports, which direction (incoming vs. outgoing), and which source addresses. The security principle underneath all of it: allow only what's specifically needed, and deny everything else by default.

Try it

Explain why a school might put guest Wi-Fi on its own VLAN, separate from the network staff computers and servers use — what's the actual risk being reduced?

Tip

"Deny by default, allow specifically" is a stronger starting position than "allow by default, block specific problems" — the first catches threats nobody's thought of yet; the second only catches ones already identified.

Play it

Open the Security Fundamentals Lab and use the Network tab.

Next: Authentication and Access Control →