4. Build It for Real¶
Same order as the simulator — but real parts don't give you an "undo" button. A few rules that don't exist in the game:
Static electricity (ESD) is real
Your body can carry a static charge you can't feel that's still strong enough to silently damage a chip. Before touching any component: touch a grounded metal object (like an unpainted part of the case, plugged into a grounded outlet but switched off), or wear an anti-static wrist strap. Avoid carpet, and don't build in a chair that generates static.
Power must be fully off
Unplug the PSU from the wall — don't just use the power switch — before installing or removing anything inside the case.
Build order¶
- Prepare the case. Remove side panels. Check for standoffs (the little screws the motherboard rests on) in the right spots for your motherboard's size.
- CPU onto the motherboard, outside the case, before anything else is attached to it. Match the alignment notch/arrow exactly — a CPU only goes in one way, and forcing it is how you break it.
- Cooler on top of the CPU. Thermal paste (if it's not pre-applied) goes on in a small dot or thin line — too much doesn't help.
- RAM into the motherboard's slots, pressed straight down until the clips click.
- Motherboard into the case, screwed down onto the standoffs.
- Storage drives mounted and connected.
- Graphics card into its slot, screwed to the case, power cables attached if it needs them.
- Cables: PSU to motherboard (main power + CPU power), PSU to GPU if needed, PSU to drives, front-panel connectors (power button, USB, audio) from the case to the motherboard.
- Cable management: route cables out of the airflow path and tie them down. This isn't cosmetic — blocked airflow means hotter components.
Try it
Build the plan from Lesson 2, in this order, for real. Take a photo after each major step (CPU installed, motherboard in case, fully cabled) — you'll want these for the final project.
Tip
If a part doesn't seem to fit, stop and double-check your Lesson 2 compatibility plan before forcing anything. Nothing in a PC build should ever require real force.
Play it
Switch the PC Parts Puzzle from Lesson 1 into wire mode and practice connecting PSU cables, front-panel I/O, and fan headers before doing it on real hardware.
Watch along
From the CompTIA A+ 220-1201 Full Course:
- Expansion cards (3:21:51) — installing a graphics card
- Cooling solutions (3:26:24) — installing a CPU cooler